MANIFOLD repLAceMeNt
INstructIONs
NOTE: The grills illustrated or photographed may have slight differences than the model purchased.
THIS PROCEDURE MUST BE PERFORMED BY AN AUTHORIZED
WEBER-STEPHEN PRODUCTS CO. SERVICE TECHNICIAN.
(ANY UNAUTHORIZED REPAIRS WILL VOID WARRANTY PROTECTION).
DANGER: BEFORE PERFORMING ANY WORK MAKE SURE THE GAS SUPPLY IS TURNED OFF AT THE SOURCE.
FAILURE TO FOLLOW DANGERS, WARNINGS AND CAUTIONS CONTAINED IN THIS INSTRUCTION SHEET MAY CAUSE A
FIRE OR AN EXPLOSION RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
WARNING: GENUINE WEBER-STEPHEN REPLACEMENT PARTS MUST BE USED FOR ANY REPAIR OR REPLACEMENT.
YOUR ACTIONS, IF YOU FAIL TO FOLLOW THIS PRODUCT WARNING, MAY CAUSE A FIRE, AN EXPLOSION, OR
STRUCTURAL FAILURE RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
(WILL VOID ALL WARRANTY PROTECTION.)
MANIFOLD
REPLACEMENT
56413 08/06/09
1
CONTROL PANEL REMOVA
L
TOOLS NEEDED:
- PHILLIPS
BEFORE STARTING: Make sure the lid is down and the casters
are locked to prevent the grill from moving.
A) Remove all of the burner control knobs by pulling up.
A B
A - Part# 41788
B - Part# 41787
B) Remove the black phillips head screw and nylon washer on the left and
right side of the control panel.
Part # 42536
Part # 42537
To Next Page
Need help?
General
