20
English
DISPLAY - AVANTGARDE
clock set-up
09:16 18-02-05 1
auto on/off
on 08:50
working days
1 2 3 4 5 6 7
reg. softener
00000000
cup heater
80°c
lAnguage
English
auto on/off
off 18:50
dispenser alarm
000 000 000
boiler pressure
0,0 atm is=0,0
1,0 atm 120°C P
09:16 09-02-04 1
13. Programming of parameters of the machine
The system automatically exits the programming phase after about
20 seconds from the last operation carried out. When programming
is finished, turn the programming
switch
back on OFF
.
i
Turn the programming switch to the ON position (P flashes on the display).
Keep the MODE key pressed for at least 3 seconds to have
access to programming.
To scroll through the various areas of the programming menu (see
alongside) use the MODE key .
Use the ENTER key to move from a parameter to the next
one within the same area.
To modify the value of each parameter, use the increase and
decrease keys.
With the programming
switch
in the ON position, the selections
are not active
.
i
To Next Page
Loading...
Need help?
General
