Wega Polaris EVD

22
English
DISPLAY - AVANTGARDE
When the machine reaches 90% of the value set on the display a signal appears for 5 seconds. When the
machine reaches 100% of the value set on the display a blinking signal appears.
To eliminate the blinking signal and reset the count of the litres of water to zero, with the programming
switch in the ON position press the 4 keys of the left push button panel simultaneously
until the display shows the message "clock set up ".
The regeneration control is bypassed by setting a value equal to 00 litres.
i
Programming of the automatic warning of water softener regeneration:
1) Enter programming until showing on the display;
2) set the amount of water (steps of 50 litres) with the keys ;
3) to move to the subsequent programming press the key MODE .
reg. softener
000000
13.5 WATER SOFTENER REGENERATION programming
In English it is possible to choose between degrees Celsius (°C) and Fahrenheit (°F)
i
language
English
Programming of the language displayed:
1) Enter programming until showing on the display;
2) set the language with the keys ;
3) to move to the subsequent programming press the key MODE .
13.7 LANGUAGE programming
Control of the dispensers alarm. The 3 values displayed correspond to the
delivery groups.
13.8 DOSERS alarm
doser alarm
000 000 000 000
doser alarm
021 007 000
reset counting ?
press + 3 sec.
doser alarm
000 000 000
1) P lace the programming switch in the ON position ;
2) with the key MODE scroll the menu until the dispenser alarms;
3) to start resetting press the key ;
4) to confirm resetting press the key for 3 seconds;
5) upon completion turn the programming switch back to OFF .
14.1 Resetting of dosers alarm
14. Resetting data to zero