25
English
CAPPUCCINO MAKER
ENGLISH
• Put the suction tube inside the milk;
• place the jug under the spout of the cappuccino maker;
• turn the steam tap counter-clockwise, upon reaching the desired
amount, close the steam tap;
• pour the foamed milk into the cups with coffee.
C appuccino maker
1
position
Hot milk
position
Cappuccino
To obtain delivery of warm milk without foam, lift the tab (1)
upwards. For better results, we suggest not dispensing directly into
the coffee cup, but into a jug or pot, then putting the foamed milk
with the coffee.
Be sure the cappuccino maker is kept clean as described in the
chapter "Cleaning".
i
Cleaning
Use special care in cleaning the cappuccino maker, following the procedures indicated here:
• initially wash by placing the immersion tube in water and run a delivery for a few seconds;
• turn the rotating body (
1) 90° to pos.B (closure of milk outlet duct);
• holding the aspiration tube in the air, dispense steam (cappuccino maker dry run);
• wait about 20 seconds to allow for internal cleaning and sterilisation of the cappuccino maker;
•
close the steam and put the rotating body back in
pos.A
;
• if the air intake hole is blocked (2), clear it gently with a pin.
1
pos. A
pos. B
2
It is advisable to clean the cappuccino after each period of continued use so as to avoid malfunctions and
to ensure the hygiene of the system.
i