※
Turn the ywheel to the accurate scale required.
※
Tighten bolts with the torque of 120-150 Nm and smear 242
sealant on the thread
● Check the fuel supply advance angle.
※
Turn the engine until fuel pump supplying fuel for 1st cylinder, and
then check whether the scale is right or not.
※
Check again, and the method is as the above.
※
Tighten the high pressure pipe of 1st cylinder
Note:
※
Turning direction of the flywheel should be same as that of
crankshaft of engine.
※
Make sure the accurate scale required.
To Next Page
Loading...
Need help?
General
