● Heat ange to 290
℃
, and its color becomes yellow. Heat crankshaft
gear to 180
℃
(the heating temperatures are recommending results, they
should be due to assembling condition)
Note
：
Not allowed to assemble when the color of the gear and flange is
purple.
● Remove the burr of at key and key groove, and then mount the
at key, crankshaft gear and ange. Hit the cylindrical pin into the end of
crankshaft.
● Drive rivet in the tilting bore of crankshaft, then punching pin used
to punch two dots to x rivet.
2.2 Pre-assemble & Assemble Crankshaft
2.2.1 Assembling Steps (1)
To Next Page
Loading...
