WEICHAI WD10 - Assemble Cylinder Liner

27
● Rub camshaft, check and make sure no scratching, then put the
camshaft in its bore.
● Assemble the thrust ake of camshaft, and loosen hexagon bolt,
then tighten it.
● Smear the thrust flake with lubricating oil, then rotate camshaft
to check the axial clearance, and make sure it’s rotating freely with no
retarding.
Note
：
※
Check camshaft bush and make sure there’s no scratching. Not
allowed to use it after repair.
※
Before putting camshaft in, the guide tool must be lubricated with
clean oil.
※
When putting camshaft in, pay attention in case of scratching
camshaft bush.
※
Smear thread of bolts with 242 sealant
2.1.3 Assemble Cylinder Liner
● Rub cylinder bore and inner and external walls of cylinder liner.
● Smear outer wall of cylinder liner with 0#, and then put the cylinder
liner in its bore.