Weider 6900 - Page 11

11
8
58
59
68
58
21
9. Attach the Leg Bumper (60) to the Front Leg (7)
with an M4 x 25mm Self-tapping Screw (69).
Make sure that the end of the Leg Bumper is
pointing upward.
10. Apply grease to an M10 x 64mm Bolt Set (76).
Attach the Leg Lever (8) to the Front Leg (7) with
the M10 x 64mm Bolt Set (76). Make sure that
the barrel of the Bolt Set is inserted through
both sides of the bracket on the Front Leg.
9
10
8. Attach the Top Frame (4) to the Upright (3) with
two M8 x 65mm Bolts (68), two M8 Washers
(59), and two M8 Locknuts (58); do not tighten
the Locknuts yet.
Attach the Top Frame (4) to the Weight Guides
(21) with two M10 x 25mm Screws (77); do not
tighten the Screws yet.
See steps 3 to 8. Tighten the M10 Locknuts (56)
and the M8 Locknuts (58).
4
3
7
77
76
76
Grease
60
69
8
7