EasyManuals Logo

Weider MAX XP400 User Manual

Weider MAX XP400
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
iMPORTANT PRECAUTIONS
kWARNi NG: Toreducetheriskofseriousinjury, readthefollowing important precautions
before using the resistance system.
1. Read all instructions in this manual before 12. Pull on the low pulley cable only while sitting
using the resistance system. Use the resist ...................... on the base plate.
ante system only as described in this manual. Pull on the high pulley cables only while sit-
ting on the bench, with the seat in one of the
2. it is the responsibility of the owner to ensure three positions closest to the upright base,
that all users of the resistance system are or while standing on the base plate.
adequately informed of all precautions.
13. The resistance system is designed to be
3. The resistance system is intended for home used with the included resistance, and the
use only. Do not use the resistance system in resistance included with a MAX by WELDER
any commercial, rental, or institutional setting. MAX PACK. Do not use the resistance sys-
tem with any other type of resistance.
4. Use the resistance system only on a level
surface. Cover the floor beneath the resist- 14. When adding resistance, both ends of the
ance system to protect the floor, resistance bars must rest under the two "U"-
channels. Add and remove resistance bars
from the "U'-channels one resistance bar at
a time.
5. Make sure that all parts are properly tight-
ened each time the resistance system is
used. Replace any worn parts immediately.
6. Keep children under 12 and pets away from
the resistance system at all times.
7. Keep hands and feet away from moving parts.
15. Keep clear of the area around the "U'-chan-
nels while the resistance system is in use.
Do not add or remove resistance bars from
the "U"-channels while the end of the long
cable is pulled out.
8. Always wear athletic shoes for foot protec- 16. Make sure that the cables remain on the pul-
tion while exercising, leys at all times, if the cables bind as you are
exercising, stop immediately and make sure
9. The top frame is not designed to be used for that the cables are on the pulleys. Replace all
pull-up exercises. Do not hang on the top
frame.
10. Always disconnect the lat bar from the short
cables when performing an exercise that
does not require it.
cables at least every two years.
17. Keep the resistance system indoors, away
from moisture and dust. Do not put the
resistance system in a garage or covered
patio, or near water.
11. 18 if you feel pain or dizziness while exercising,
The resistance system is designed to sup-
port a maximum user weight of 300 pounds, stop immediately and begin cooling down.
WARNING[]
,_L Before beg,nn,ng this or any exercise program, consult your physician. This
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. Sears assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.
3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Weider MAX XP400 and is the answer not in the manual?

Weider MAX XP400 Specifications

General IconGeneral
BrandWeider
ModelMAX XP400
CategoryFitness Equipment
LanguageEnglish

Related product manuals