25. 25
Attach the end of the Short Cable (58) to the
Long "U"-Bracket (57) with a 1/4" Nylon Lock-
nut (2) and a 1/4" Flat Washer (10). Do not
completely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable so only a couple of threads are
showing above the nut, as shown In the
Inset drawlng.
26. Attach the 3 1/2" Low Pulley (88) and the 5/8"
x 9/16" Spacer (73) to the indicated hole in
the Press Frame (17) with a 3/8" x 3 3/4" Bolt
(71), a 3/8" Flat Washer (9), and a 3/8" Nylon
Locknut (21). Do not tighten the 3/8" Nylon
Locknut (21) yet. Be sure that the 3/8" x
3 3/4" Bolt (71), the 3/8" Rat Washer (9),
the 5/8" x 9/16" Spacer (73), the 3 1/2" Low
Pulley (88), and the 3/8" Nylon Locknut
(21) am oriented as shown.
2
12
To Next Page
Loading...
