50. Wrap the Low Cable (86) around a 3 1/2" Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the welded tube on the Ab
Upright (1) with a 3/8" x 3 3/4" Bolt (76), a 3/8"
Washer (38) and a 3/8" Nylon Jam Nut (43). Orient
the wide tab on the Pulley Covers as shown.
51. Wrap the Low Cable (86) around a 3 1/2" Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the lower set of holes in the
Pulley Plates (31) with a 3/8" x 2" Bolt (50) and a 3/8"
Nylon Locknut (42). Orient the wide tab on the
Pulley Covers as shown.
50
51
82
Wide Tab
94
Tube
Wide Tab
52. Wrap the Low Cable (86) around a 3 1/2" Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the indicated hole in the Ab
Upright (1) with a 3/8" x 3 3/4" Bolt (76), two 3/8"
Washers (38) and a 3/8" Nylon Jam Nut (43). Orient
the wide tab on the Pulley Covers as shown.
52
86
38
76
Tab
19
To Next Page
Loading...
