Weider Viper 2000 User Manual

3. Press the 1 1/4” Inner Cap (57) into the Front
Upright (42).
Attach the 1” Plastic Stop (64) to the centre hole
in the Stop Bracket (63) with a 5/16” x 1 1/2” Bolt
(24) and 5/16” Nylon Locknut (3).
Attach the Stop Bracket (63) to the Front Upright
(42) with a 5/16” x 2” Bolt (61), 5/16” Flat Washer
(8), and 5/16” Nylon Locknut (3).
Slide the Front Upright (42) onto the two 5/16” x
2 1/2” Carriage Bolts (1) in the Base (4). Thread
two 5/16” Nylon Locknuts (3) onto the Carriage
Bolts. Do not tighten the Nylon Locknuts yet.
4. Press two 2” Inner Caps (27) into the Top Frame
(67).
Attach the Top Frame (67) to the Front Upright (42)
with two 5/16” x 2 3/4” Bolts (11), 5/16” Flat
Washers (8), and 5/16” Nylon Locknuts (3). Do
not tighten the Nylon Locknuts yet.
Attach the Top Frame (67) to the Stop Bracket (63)
with a 5/16” x 2 3/4” Bolt (11), 5/16” Flat Washer
(8), and 5/16” Nylon Locknut (3). Do not tighten
the Nylon Locknut yet.
Attach the Top Frame (67) to the Rear Upright (82)
with two 5/16” x 2 3/4” Bolts (11), 5/16” Flat
Washers (8), and 5/16” Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 2
through 4.
3
4
3
57
42
64
63
Single Hole
3
24
3
8
61
1
4
27
27
67
42
11
8
3
11
8
3
63
11
82
8
3
5

Weider Viper 2000 Specifications

General

Brand	Weider
Model	Viper 2000
Category	Fitness Equipment
Language	English