14. Open the parts bag labelled “CABLE ASSEMBLY
AND PULLEYS.” For cable identification and routing
during steps 14–32, refer to the CABLE DIAGRAMS
and CABLE ID CHART on pages 19 and 20.
Insert two 3/8” x 1” Bolts (15) into the welded brackets
on the Left and Right Butterfly Arms (67, 68). Secure the
Bolts with a 3/8” Jam Nut (18).
Identify the Short Cable (71). It is approximately 1,9
m long and it has a closed loop on each end. Slide
one end of the cable onto each of the 3/8” x 1” Bolts
(15). Secure the Cable to the Bolts with 3/8” Jam Nuts
(18). Do not overtighten the Nylon Jam Nuts.
Remove both 3 1/2” Pulleys (5) from the pre-assembled
Adjustable Pulley Plates (44). Wrap the Short Cable (71)
around a 3 1/2” Pulley (5) in the direction shown. Attach
the 3 1/2” Pulley and a Cable Trap (39) to the top hole in
the two Adjustable Pulley Plates (44) with a 3/8” x 2” Bolt
(35) and a 3/8” Nylon Locknut (4). Make sure the Cable
Trap and Pulley Plates are oriented as shown.
12. Press two 1 1/2” Square Inner Caps (79) into the Leg
Lever (49).
I
nsert a Bumper (33) between the brackets on the Leg
Lever (49). Secure the Bumper to the Leg Lever with a
#
10 x 1” Screw (32).
Slide the bracket on the Leg Lever (49) onto the Press
Seat Frame (52). Attach the Leg Lever to the Press Seat
Frame with a 5/16” x 2 1/4” Bolt (81) and a 5/16” Jam
Nut (90). Do not overtighten the 5/16” Jam Nut. It
must be easy for the Leg Lever to pivot.
Attach a 3/8” x 2 1/2” Eye Bolt (83) to the Leg Lever (49)
with a 3/8” Flat Washer (17) and 3/8” Nylon Locknut (4).
13. Press a 1 3/4” Square Inner Cap (37) into each end of
the Right Butterfly Arm (68). Wet the lower end of the
Arm with soapy water. Slide a 10” Pad (65) onto the
lower end of the Arm.
Lubricate the indicated axle on the Butterfly Top Frame
(64). Have a second person slide the Right Butterfly Arm
(68) onto the axle, as shown. Refer to the inset draw-
ing. Place two 1” Retainers (25), with the teeth down-
ward, on top of an inverted Round Cap (26). Using a
hammer, tap the Round Cap and the Retainers onto
the axle to secure the Right Butterfly Arm.
Repeat this step to assemble the Left Butterfly Arm (67).
Cable Assembly
90
79
49
79
4
17
83
13
26
68
67
Lubricate
65
8
1
52
33
3
2
64
25
37
12
37
14
68
39
44
4
35
67
15
15
5
71
18
Teeth
64
25
26
18
10
To Next Page
Loading...
