10
5. Slide the two Weight Bumpers (27) onto the
Weight Guides (21). Orient fourteen Weights
(22) so the pin holes are on the bottom, and
slide the Weights onto the Weight Guides.
Insert the Weight Tube (24) into the fourteen
Weights (22). Make sure that the pin on the
Weight Tube is oriented as shown.
Using the included grease packet, lubricate the
indicated holes in a Weight (22). Slide the
Weight onto the Weight Guides (21).
5
22
2
1
22
27
24
P
in
Pin
Hole
Grease
6. Attach the Top Frame (4) to the Upright (3) with
two M8 x 80mm Bolts (68), two M8 Washers
(59), and two M8 Locknuts (58). Do not tighten
the Locknuts yet.
Attach the Top Frame (4) between the Weight
Guides (21) with an M10 x 160mm Bolt (74),
two M10 Washers (57), two 13mm Spacers
(76), and an M10 Locknut (56). Do not tighten
the Locknuts yet.
6
4
3
56
58
74
21
21
59
57
76
57
68
58
To Next Page
Loading...
