WeiderPro Pro 4500 - Page 18

18
24. Identify the Low Cable (53). Route the Low
Cable through the Leg Lever (8) and the Front
Leg (7).
Attach a 90mm Pulley (48) inside the Leg Lever
(8), over the Low Cable (53), with an M10 x
75mm Bolt (85), two M10 Washers (57), two
16mm Spacers (52), and an M10 Locknut (56).
23. Thread an M12 Nut (86) all the way onto the
High Cable (55). Place a Large Washer (87) on
top of the Weight Tube (24).
Tighten the High Cable (55) into the Weight
Tube (24) until all the slack is removed from the
cables. Tighten the M12 Nut (86) against the
Large Washer (87).
23
24
55
86
87
24
8
7
53
52
52
57
57
48
85
56
25. Attach a 90mm Pulley (48) inside the Front Leg
(7), over the Low Cable (53), with an M10 x
80mm Bolt (71), two M10 Washers (57), two
19mm Spacers (33), and an M10 Locknut (56).
25
56
7
53
33
33
57
57
48
71