Delay to Start (ms) – The delay to start value indicates how many
milliseconds to wait until the feeder motor begins to activate. (100
by default.)
Rotation Angle (°) – This is the total number of degrees (default =
360°) that the stepper motor will rotate. This should only be used if
high speed is required. Contact your support provider for the proper
settings. (This is an Advanced Setting)
Offset (°) – The offset will modify the home position of the stepper
motor. This should only be used in specialty applications. Contact
your support provider for the proper settings. (This is an Advanced
Setting)
Open Step Time (ms) – This is the number of milliseconds the
stepper motor will take to rotate one step during the opening
process
Open Time Padding– This is a percentage of the Open Step Time
that will be applied to the stepper to slow the motor down during
critical parts of the rotation. This will only become critical in high-
speed applications. Contact a service technician for optimal
settings. (This is an Advanced Setting)
Pause Time (ms) – This is the duration, in milliseconds, that the
bucket will stay open before closing and is product-dependent. If
you are unsure of what to set here please contact a service
technician.
Close Step Time (ms) – This is the number of milliseconds the
stepper motor will take to rotate one step during the closing
process.
Close Time Padding – This is a percentage of the Close Step
Time that will be applied to the stepper to slow the motor down
during critical parts of the rotation. This will only become critical in
high-speed applications. Contact a service technician for optimal
settings. (This is an Advanced Setting)
To Next Page
Loading...
