65
January, 2017
Stepper Pattern Screen
The Stepper pattern Configuration screen allows the advanced configuration of the opening and closing
pattern for the Weigh and Feed bucket stepper motors. All PrimoCombi stepper motors perform a series
of 20 steps per 360 degree rotation. These are clustered into two groups of 10, one for the opening of the
bucket and one for the closing of the bucket. This screen can only be accessed if the Advanced
Components box is checked from the Hardware screen.
SAVED CONFIGURATIONS
The saved configuration section is where all your different configurations will be
saved. You can create as many different head settings as you wish, limited only
by the disk space of the computer hosting the Database.
To Next Page
Loading...
