上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
26 Specialized, Concentrated, Focused
If P is omitted, it indicates setting tool offset value for the current tool.
Programming Example (the cutter lifting program in Public.dat)
M802 P196609
M801 MSG"|D| wait for tool calibration signal"
G904 FZ-60 PZ=#CALIBRATION_SW LZ1
M801 MSG""
M802 P196608
G903 G00 G91 Z5
G923 z0
G906
G923 Z = #CURWORKPOS.Z-#MOBICALI_THICKNESS–5
Canned Cycle Function
The canned cycles of CNC mills are mainly used for machining holes, including drilling, boring
and tapping. With one program block, you can accomplish one or a full set of hole machining
operation. When continuing hole machining, if there is no need to change hole machining operations,
all the modal data in the program needn’t to be written, which can greatly simplify the program.
Description of each command is shown in the following table.
Operation at bottom of
hole
High speed peck drilling
cycle
Oriented spindle stop with
one displacement
Drilling cycle of dwell at
bottom of hole
Semi-automatic fine
boring cycle
To Next Page
Loading...
Need help?
General
