WEIHONG ELECTRONIC Ncstudio - G Codes Related with Encoder; G916 Writing Axis Configuration Data Command

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
50 Specialized, Concentrated, Focused
Programming Example:
δ =10
37
Φ
10
Through hole
Fig. 4-37 Repeated Canned Cycle Machining
Take a repeated canned cycle to drill holes as shown in Fig. 4-37.
Programming is as following:
N01 G90 X0. Y0. Z100.
N02 G00 X-50. Y51.963 M03 S800
N03 Z20. M08 F4000
N04 G91 G81 X20. Z-18. F4000 R-17. K4
N05 X10. Y-17.321
N06 X-20. K4
N07 X-10. Y-17.321
N08 X20. K5
N09 X10. Y-17.321
N10 X-20. K6
N11 X10. Y-17.321
N12 X20. K5
N13 X-10. Y-17.321
N14 X-20 K4
N15 X10 Y-17.321
N16 X20. K3
N17 G80 M09
N18 G90 G00 Z100.
N19 X0. Y0. M05
N20 M30
G Codes Related with Encoder
G916 Writing Axis Configuration Data Command
Format: G916 PX[_]LX_PY[_]LY_PZ[_]LZ_
Description: