上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
Manufacturer's Manual of Ncstudio V15 Laser Cutting
(LS1500, LS3000, LS8000M) Control System
Version: 2022.08.23 V1
Author: Product Testing Department
Weihong Corporation All Rights Reserved
Contents
1 Quick Start ........................................................................................................................ 1
1.1 Overview .................................................................................................................... 1
1.2 Hardware Connection Diagram .................................................................................. 1
1.3 Shortcut Keys ............................................................................................................. 3
2 Install the System ............................................................................................................. 5
2.1 Overview .................................................................................................................... 5
2.2 Install Follow-up Amplifier .......................................................................................... 5
2.3 Install Motion Control Card ......................................................................................... 5
2.4 Install the Software ..................................................................................................... 5
2.5 Install the Drive........................................................................................................... 6
2.5.1 Automatic Installation ........................................................................................... 6
2.5.2 Manual Installation ............................................................................................... 7
3 System Debugging............................................................................................................ 8
3.1 Overview .................................................................................................................... 8
3.2 Configure Settings in NcConfig .................................................................................. 8
3.2.1 Data Backup ........................................................................................................ 9
3.2.2 Data Restoration .................................................................................................. 9
3.2.3 Device and Port Mapping Configuration .............................................................. 9
3.2.4 Port Protection ................................................................................................... 10
3.3 Modify I/O Port Polarity ............................................................................................ 11
3.4 Set Drive Parameters ............................................................................................... 11
3.4.1 Set Drive Parameters in Non-bus Control Systems ........................................... 12
3.4.2 Set Drive Parameters in Bus Control Systems .................................................. 30
3.5 Set Bus System Parameters .................................................................................... 33
3.6 Set Speed Parameters ............................................................................................. 33
3.7 Set Pulse Equivalent ................................................................................................ 34
3.8 Check Axis Direction ................................................................................................ 35
3.9 Set Workbench Travel Limits ................................................................................... 35
3.10 Set the Screw Error Compensation ........................................................................ 35
3.10.1 Set the Backlash Compensation ...................................................................... 36
3.10.2 Set the Bidirectional Compensation ................................................................. 36
3.11 Check Machine Settings ......................................................................................... 37
3.11.1 Pulse Equivalent and Electronic Gear Ratio .................................................... 37
3.11.2 Pulse ................................................................................................................ 38
To Next Page
Need help?
General
