WEIHONG LS1500 - Shortcut Keys

119 pages

To Next Page

To Previous Page

上海维宏电子科技股份有限公司

SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.

3 / 116

1.3 Shortcut Keys

The shortcut keys are as follows:

Main Page

Table of Contents1
Quick Start4
Overview4
Hardware Connection Diagram4
Shortcut Keys6
Install the System8
Overview8
Install Follow-Up Amplifier8
Install Motion Control Card8
Install the Software8
Install the Drive9
Automatic Installation9
Manual Installation10
System Debugging11
Overview11
Configure Settings in Ncconfig11
Data Backup11
Data Restoration11
Device and Port Mapping Configuration11
Port Protection12
Modify I/O Port Polarity14
Set Drive Parameters14
Set Drive Parameters in Non-Bus Control Systems14
Set Drive Parameters in Bus Control Systems15
Set Bus System Parameters36
Set Speed Parameters36
Set Pulse Equivalent37
Check Axis Direction38
Set Workbench Travel Limits38
Set the Screw Error Compensation38
Set the Backlash Compensation39
Set the Bidirectional Compensation39
Check Machine Settings40
Pulse Equivalent and Electronic Gear Ratio40
Pulse41
Laser Technic Settings41
Do a Burn Test42
Install and Use the Camera42
Modify the Computer IP Address42
Modify the Camera IP Address43
Follow Debugging45
Overview45
Tab Area45
Coordinate Area45
Manual Control Area45
Follow Control Buttons45
Follow Control Area/Follow Parameter Setting Area45
Operations50
Prepare50
Measure the Capacitance50
Execute Servo Calibration50
Execute Calibration50
Check the Follow Function52
Follow Parameter52
System Setting52
Follow Setting52
Calibrate Setting52
Speed Setting52
Real-Time State Check52
Manual Speed52
Common Problems57
Serious Electric Interference57
Capacitance Is Not Zero When Touching the Material57
Cutter Continues Lowering after Touching the Material During Calibration57
Actual Follow Height Differs from Setting57
Cutter Stops Working Frequently When Capacitance Feedback and Calibration57
Results Are Normal59
Cutter Has Severe Jitters When Cutting Thin Plates and Causing Workpiece Outline Deformation59
System Reports Follow Error When Moving Z Axis or Enable Follow59
Encoder Direction or Axis Direction Error59
Follow In-Position Waiting Timeout60
Large Follow Error Alarm60
System Reports Material Collision Alarm When Follow Is Enabled in Idle Status or During Machining60
System Reports Material Collision Alarm When the System Has no Movement60
Follow Overshoot61
Wiring62
Controller and Terminal Board62
Lambda Controller62
Extension Terminal Board63
Laser65
IPG-YLR Series Laser65
Feibo MARS-500W Laser66
Raycus Fiber Laser66
JK / GSI-500W-FL Laser67
MAX Fiber Laser68
SPI-500W-R4 Laser68
HFB 1000-1500W Laser69
GW Smatlas 3S Laser70
Wiring Diagram of the Drive71
Drive Port Definition71
Wiring Diagram of the Drive (in Position Control Mode)73
Wiring Diagram of the Drive (in Velocity Control Mode)94
Wireless Handwheel110
Whb05L(V4)110
Whb05L(V5)112
Whb05N(V1)115
Specifications117
Precautions117
Faqs117
Legal Notices118
Requirements of Use118
Intellectual Property Rights Notice118
Termination119

WEIHONG LS1500 - Shortcut Keys

Table of Contents

Related product manuals