上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
39 / 116
3.12 Do a Burn Test
At the first commissioning for the machine tool, a burn test is required to make sure the
motion stability of each axis.
Before doing a burn test, make sure all axes are at the machine origin.
To do a burn test, do the following:
1. In the menu bar, click Machining > Burn Test to open the Burn Test dialog box:
2. Select the target axis, and set the start position, end position and speed at 1st, 2nd
and 3rd stage for the burn test.
3. Optional: Check Enable Switch and set Interval in Other Param area.
4. In the Control area, set Time in 1st, 2nd and 3rd stage for the burn test.
5. Optional: To check the history records of burn tests, click History.
6. Optional: Check Shield Collision and Cuttinghead Alarms(Risk of collision,
please use with caution!).
Warning: Risk of collision. Please use it with caution!
7. Click Start. The system starts to do a burn test.
During a burn test, to stop it, click Stop.
3.13 Install and Use the Camera
When installing the NcStudio V15 laser cutting control system, you can select whether
to enable the camera functions for machining monitor and control.
Currently, only Hikvision and Dahua Technology cameras are supported.
Follow the steps below to install and use a camera:
1. Connect the camera to the computer.
At most two cameras can be connected at the same time.
2. Acquire the camera IP address, port, subnet mask, and default gateway:
o Hikvision: Use the SADPTool.exe software.
o Dahua Technology: Check the camera manufacturer's manual.
3. Modify the computer or camera IP address as shown below:
o Modify the computer IP address
To Next Page
Loading...
