上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
40 / 116
o Modify the camera IP address
3.13.1 Modify the Computer IP Address
Follow the steps below to change the computer IP address:
1. Taking Ethernet 3 as an example, follow the steps below to set the computer IP
address based on the acquired camera information to make the computer and
camera connected:
a. Go to Control Panel > Network and Internet > Network and Sharing
Center > Ethernet 3.
b. Go to Properties > Internet Protocol Version 4 (TCP/IPv4) > OK.
c. Select Use the following IP address and enter an IP address that is in the
same network segment with the camera IP address. Click OK.
The IP address first three sections, subnet mask, and default gateway need
to be the same as those for the camera. The last section of the IP address
needs to be different from that of the camera IP address.
2. In the NcStudio menu bar, click System > System Parameters. In the External
Device > 3.0 Monitoring category, set Enable Camera to Yes.
3. In the camera monitor area, click login in the right-click menu:
4. Select the camera type, camera IP address, port number, username, and password.
After logging in, the camera image will be displayed in the camera monitoring area.
Double-click in the camera monitor area to switch between different numbers of cameras.
If the camera is replaced in the future, click Logout in the right-click menu in the camera
monitor area and repeat the previous steps to log in again.
To Next Page
Loading...
