WEIHONG LS1500 - Page 55

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
52 / 116
o Range: -255–255
o Value: 0
 Part Touching Delay (Positioning)
o Description: Indicates the part touching delay during positioning.
o Range: 0 ms–20000 ms
o Value: 300
 Part Touching Delay (Follow-up)
o Description: Indicates the part touching delay during following.
o Range: 0 ms–20000 ms
o Value: 500
 Part Touching Delay (Punch)
o Description: Indicates the part touching delay during piercing.
o Range: 0 ms–20000 ms
o Value: 600
 Enable Anti-collision
o Description: After this parameter is enabled, if the system detects during dry
running that the cutter may have a collision, the cutter will be lifted
automatically.
o Range
 Yes: enable
 No: disable
o Value: Yes
 Speed Gain
o Description: Available in velocity control mode. Its value equals to the motor
rated power divided by 10V. It matches the motor velocity speed command
input gain.
o Range: 10–2000
o Value: 300
 Cutting Head Alarm Tolerance
o Description: Indicates the capacitance change threshold that triggers the
cutter exception alarm.
o Range: 100 Hz–100000 Hz
o Value: 500
 Cutting Head Alarm Additional Tolerance
o Description: The capacitance change threshold that triggers the cutter
exception alarm will equal Cutting Head Alarm Tolerance plus Cutting
Head Alarm Additional Tolerance if Capacitor Compensation is enabled.
o Range: 100 Hz–100000 Hz
o Value: 1500
 Capacitor Compensation
o Description: Indicates whether to enable capacitance compensation.
o Range
 Yes: Enable
 No: Disable
o Value: No
4.3.4 Calibrate Setting
Includes the following parameters:
 Nonmetal Calibration
o Description: Specifies the type of material to be calibrated.