weinor BiEasy 15M Go! - Programming the Transmitter

Ⓒ weinor GmbH & Co. KG EN | 75
4.6 Programming the transmitter
For programming receivers, a maximum of 15 individual
channels are available. After selecting the channel, the
programming process can be started with the P button.
During an ongoing programming process, it is possible to
switch between empty and already programmed channels
(except when programming in a channel that has more than
10 receivers at the same time).
Requirement:
The bidirectional receiver is installed.
Stand in front of the blind to be programmed while
programming.
1. Where electrical receivers have already been installed,
switchthecircuitbreakero󰀨andonagainafterafew
seconds. The receiver will now be in programming mode
for about 5 minutes.
2. Engage the programming button P on the rear of the
devicebriey(approximately1second)untilthestatus
displaylightsupbriey.Theblindmovesupanddownfor
approximately two minutes, showing that the receiver is
in programming mode.
3. Immediately (no more than 1 second) after the curtain
starts moving upwards, press the UP button.
Thestatusdisplaylightsbriey.
Theblindstopsbriey,startsmovingagainandthen
moves downwards.
BiEasy-15Mgo_weinor_BA_18112801_DE+EN_0218.indb 75 26.02.2018 13:50:48