PergoTex II/ PergoTex II LED
Maintenance Instructions and Directions for Use
We reserve the right to make technical changes
5 Cleaning and care (By the user)
5.1 Cleaning and maintenance work in the opening space of the weinor PergoTex II
There is a risk of motorised sun protection units being activated unintentionally. Always ensure
that the weinor PergoTex II is completely switched off (e.g. by disconnecting the fuse) before
performing maintenance and cleaning work (e.g. building cleaners).
If the weinor PergoTex II is operated by several users, a steering priority locking device must be
installed (controlled interruption of the power supply from outside), making it impossible to open
or retract the weinor PergoTex II at all.
5.2 Cleaning
The following points should be carried out at least twice a year, in spring and the autumn and
after longer downtime:
Intensive cleaning of the construction, in particular the side channel, gutters and fabric
Even a low-maintenance product needs to be cared for. For this reason, please carry out the
following maintenance and care tasks as required, once every spring, or whenever the awning
has not been in use for a long time. Performing these tasks will extend the operating life of your
awning system. Foliage and other foreign bodies as well as heavy dirt must be removed
5.3 Foliage and foreign bodies
Foliage and other foreign bodies as well as heavy dirt
• in the guttering
• in the side gutters to the left and right of the side channels
• on the fabric, etc.
must be removed immediately.
In general, all the water drainage gutters on the roof and side channels should be regularly
checked for dirt and cleaned accordingly.
Any cleaning work not carried out may lead to the premature wear of gaskets and to
leaks.
Rainwater outlet holes
• in the posts
• in the gutter,
• in the guttering safety shield
must be kept unblocked at all times to ensure that water can drain off. It is recommended that
this is checked and cleaned accordingly twice a year, in spring and the autumn.
5.4 weinor PergoTex II care
Your weinor PergoTex II has been designed for low-maintenance. In the unlikely event that it
should fail, the service work should be performed by a specialist company.
If lubricants are required during the service work, use greases, sprays or liquids that contain
elements of Teflon, PTFE or comparable agents. For best, long-lasting effects, the lubricant
must be water- and dirt-repellent. The manufacturer's guidelines must be observed at all times.
Do not use lubricants that corrode plastics.
To Next Page
Loading...
Need help?
General
