weinor PergoTex II Maintenance Instructions And Directions For Use

PergoTex II/ PergoTex II LED
Maintenance Instructions and Directions for Use
Version 7
2020-05-08
We reserve the right to make technical changes
Item number
118702-0000
Page 14/16
6.2 Rectifying faults
Error
Cause
Remedy
• System not running
• No power supply
• Drive incorrectly connected
• Motor is too hot and has
been shut down by the
thermo protector
• Connect to the mains
• Connect to the mains
(authorised personnel only)
• Wait approx. 15 to 20
minutes until the motor has
cooled down
• Squeaking
• Bearing surfaces not
lubricated
• Maintenance and care (fitter)
• Light off
• No power
• Establish a power supply
voltage
• Notify your retailer and
partner (rectification by
specialist)
7 Retrofits
Your weinor PergoTex II can also be retrofitted with automatic control units, e.g. with sun and
rain sensors and glazing elements. For more details, contact your specialist retailer,
who will be happy to advise you.
8 Noise level
During ascending and retraction, the noise level of the weinor PergoTex II has been measured at
below 70 dB(A).

weinor PergoTex II Specifications

General

Brand	weinor
Model	PergoTex II
Category	Accessories
Language	English