PergoTex II/ PergoTex II LED
Maintenance Instructions and Directions for Use
We reserve the right to make technical changes
6 Maintenance and rectifying faults (by a suitable specialist retailer)
6.1 Maintenance
Caution! Non-regular maintenance and unprofessional troubleshooting of malfunction
can impair the functioning and safety of the construction!
Have maintenance carried out regularly 1x per year by a specialist company!
Non-regular maintenance and unprofessional troubleshooting leads to loss of warranty
claims.
Inspect the weinor PergoTex II at regular intervals for signs of wear and tear or
damage to the cables and leads. Do not use units that are in need of repair.
- Check the electronics and control units
- Touch up/repair any damage to the paintwork on the aluminium profiles
- Check that all rubber gaskets and permanently elastic seals are correctly
positioned
- Check the grouting and repair if necessary
- Check all gaskets, seals, etc. between the PergoTex II and the on-site connections,
and repair as necessary
Inspect the weinor PergoTex II at regular intervals for signs of wear and tear or
damage to the cables and leads.
The following points should be carried out at least twice a year, in spring and the
autumn and after longer downtime:
- Greasing the pulley blocks in the front and wall support caps
- Checking the toothed belt's tension force
- Checking the end position of the motor
- Checking the fabric for visible damage
- Check the seal at the wall connection and the gutter and repair if necessary
In addition the following points should be carried out at least four times a year:
- General check that everything is working
- Checking the fabric tension force so that rainwater can be drained off properly
Do not operate or use any constructions that are in need of repair.
To Next Page
Loading...
