PergoTex II/ PergoTex II LED
Maintenance Instructions and Directions for Use
We reserve the right to make technical changes
3.4 Use in rain
To achieve the best rain drainage, the weinor PergoTex II should be set at an angle of more
than 8°.
3.5 Important guidelines for the winter season
The weinor PergoTex II is not designed to withstand extreme snowfalls or avalanching snow
loads. These have to be removed from the safety shield surface. As necessary, a snow guard
may need to be installed.
Figure 3: Removing avalanching snow
3.6 Automatic controls
A weinor PergoTex II must never be left unattended when open. The automatic controls may
fail under extreme conditions (e.g. power failures, defects, sudden storms). There is a risk that
the weinor PergoTex II could be damaged.
Our recommendation: if you vacate the area, switch the weinor PergoTex II from automatic
system control to manual control and leave it retracted.
3.7 General notes on the fabric
It is perfectly normal for a small amount of condensation to form on the fabric according to the
weather. This does not form grounds for complaint, non-acceptance or price reductions.
A PVC fabric which has been extended for a prolonged period can lose its tautness due to the
outside temperature and the effects of sun radiation.
To Next Page
Loading...
Need help?
General
