To Next PageTo Next Page
Need help?Do you have a question about the Weiser Powerbolt 1 and is the answer not in the manual?
Verify the primary door hole diameter is 2-1/8 inches (54 mm) for proper fit.
Confirm the door's backset is either 2-3/8 or 2-3/4 inches (60 or 70 mm).
Ensure the hole on the door's edge is 1 inch (25 mm) for the latch.
Verify the door thickness is between 1-3/8 and 1-3/4 inches (35 or 44 mm).
Install the latch, ensuring the slotted hole is centered and flush with the door edge.
Details for installing the latch on chiseled or non-chiseled door edges.
Methods for securing the latch and installing the strike plate on the door frame.
Verify the latch bolt is fully retracted before proceeding with installation.
Route the connecting cable below the latch for the exterior assembly.
Hold the exterior assembly securely on the door's outer side.
Feed the connecting cable through the designated bottom hole to the exterior assembly.
Secure the mounting plate and insert the tailpiece into the latch mechanism.
Connect the cable to the interior assembly, ensuring proper alignment and a secure fit.
Mount the main interior assembly onto the door and test turnpiece rotation.
Fasten the interior assembly to the mounting plate with screws.
Insert 4 AA batteries into the interior assembly, ensuring correct polarity.
Configure the lock's direction based on the latch position (left or right).
Step-by-step guide to creating a new 4-8 digit user code for access.
Verify the lock extends to lock and retracts to unlock using the user code.
Use a 9V battery to temporarily power the lock when AA batteries are low.
Connect a 9V battery to terminals to unlock the door during low battery.
Reattach the terminal cover after using the temporary power source.
Information on the product's compliance with Federal Communications Commission rules.
Details regarding compliance with Industry Canada's RSS standards.
Addresses common problems like lock unresponsiveness, beeping errors, and latch operation failures.
Key safety advice including reading instructions, understanding warnings, and family awareness.
Guidelines for protecting user codes and securing the interior assembly.
Proper procedures for handling and disposing of batteries.
General| Brand | Weiser |
|---|---|
| Model | Powerbolt 1 |
| Category | Door locks |
| Language | English |
