6
3 Technical description
3.1 Permissible applications
The Weishaupt oil burner WL10 is suitable for:
• heat exchangers complying with EN303-2 or
DIN4702-1
• for warm water installations with intermittent or
continuous run (combustion manager switches off
once in 24hrs.)
• air heaters
Any other use is only permissible with the written
agreement of Max Weishaupt GmbH.
• The burner must only be operated with oil to DIN
51603-EL-1, fuel oil EL to ÖNORM-C1109 or stan-
dard fuel oil, Euro quality to SN 181 160-2 or prefer-
ably Öko fuel oil, CH quality to SN 181 1602
• Permissible ambient conditions see Ch. 8.5
• The burner must not be used outside. It is only suited to
inside operation.
• The burner must not be used outside of its capacity
range (see capacity graphs, Ch. 8.2).
• To ensure low emission combustion heat exchangers of
the three pass principle and combustion chamber
dimensions to EN 267 are recommended.
Type designation:
Typ
W L 10 /2 -C, vers. Z
Two stage
Construction type
Ratings range
Size
L = Fuel oil EL
Weishaupt burner type W
Note: The burner in its delivered condition is not
factory pre-set, and requires to be
commissioned.
To Next Page
Loading...
Need help?
General