Weishaupt WRS - Call up and Change Timer Program (Only Possible on the WRS-CPU-B2;E)

19
6
6.7 Call up and change timer program (only possible on the WRS-CPU-B2/E)
Why?
 Independent time program, freely
programmable timer, i.e. circulation
pump.
 In program 5, up to three cycles can be
entered for each week day.
 A standard program has been factory preset
(see Ch. 9.1). You can reset this standard
program with your program 5 at any time
(see Ch. 6.13)
 Program 5 can be assigned to MFA relay
output (230 V, plug No. 3) and burner
stage 2 (potential free contact, plug No. 20)
of the CPU (see heating engineer level,
parameter 174 ➩ “Prog 5”).
Example for 2 program cycles on one day
0h 6h 12h 18h
Ein
Aus
1. Start 1. End 2. Start 2. End
1. Cycle
2. Cycle
On
1:Operator -/+
Program 5
ProgCycle Mon.
1
ProgCycle Mon.
1
ProgCycle Tues.
2 ProgZ.....
ProgCycle Wed.
3 ............
ProgCycle Week
8
Mo:1.Start06:00
1
Mo:2.Start--:--
1
Mo:1.End 22:00
1
Mo:2.End --:--
1
Mo:3.Start--:--
1
Mo:3.Start--:--
1
- or -
next week day?
return?
If no entry at “2.Start”
Press
Turn until
display
shows
Press to call up
circulation program
Press to call up circ. cycle
Monday
If entry at “2.Start”
In parameter 8 you can set a heat cycle
for the whole week. This takes
precedence over settings made for
individual week days.
Press to confirm entry
Press to confirm entry
If entry at “3.Start”
On
Off