20
6
6.8 Call up and change temperature setpoints
Why?
Your heating control operates to different
temperature setpoints, stipulated by you.
Normal temperature setpoint:
Your selected room temperature.
Economy temperature setpoint:
Your selected room temperature outside of
operating times, for example during the
night.
Frost protection temperature setpoint:
Protects the building from frost damage.
Please note: Frost protection is only
ensured if the heating system functions
correctly.
Note: The frost protection temperature only has an
effect if the room factor is activated.
Summer/Winter switchover temperature:
Operation without intervention for a whole year is
possible.
The heating system does not start during short cold
snaps.
Summer/Winter switchover is not carried out
depending on the current external temperature, but
depending on an average external temperature
determined over time (External dampened). With this
the heating is switched off when the dampened
external temperature is 2° C above the switchover
temperature. If the dampened external temperature
is 1° C below the switchover temperature, the heating
circuit is re-activated. The dampened external
temperature can be called up in the heating engineer
level parameter ➩ 111.
DHW temperature setpoint:
You program the required hot water temperature into your
heating control.
Danger of scalding!
Excessively high hot water temperatures can
lead to scolding.
To Next Page
