General instructions 5
Safety instructions 6
About the Weishaupt Controller System 7
3.1 System execution 7
Operating and display elements of the direct setting level 8
How do I operate my heating system 9
5.1 Tips for comfortable ambience and economical heating 9
5.2 Changing room temperature/direct setpoint adjustment 9
5.3 Temporarily interrupting or extending the
heating program 9
5.4 Requesting information - Info mode 10
5.5 Selecting type of operation 11
5.6 Manual operation/Chimney sweep 12
Additional setting possibilities 13
6.1 Operating and display elements of the extended
setting level (flap open) 13
6.2 Where do I find ... ? 14
6.3 Removing the operating unit from its holder –
read/write data 15
6.4 Correcting time and change start/end of summer time 16
6.5 Call up and change heating program 17
6.6 Call up and change hot water program 18
6.7 Call up and change timer program
(only possible on the WRS-CPU-B2/E) 19
6.8 Call up and change temperature setpoints 20
6.9 Call up and change heating reference line
(weather compensated) 21
6.10 Energy saving function 22
6.11 Set holiday start/end 23
6.12 Type of operation 24
6.12.1 Set type of operation/call up error messages/
call up burner run time 24
6.13 Reset “Service” or “Flue Gas Limit” message
to factory settings 25
Operation with several address settings 26
7. 1 Unit selection on multiple heating circuits 26
7. 2 Special feature: Address 0 26
7. 3 Central operating unit (control point) address 0, 2 26
7. 4 Special feature: Address 2 27
What to do if ... ? 28
8.1 Error and service messages on the display 28, 29
8.2 Additional displays 30
8.3 Dwelling to cold or too warm 31
8.4 Deactivate heating circuit 31
8.5 Pump run on time 31
8.6 Sensor recognition 31
3
Contents
1
2
3
4
5
6
7
8
To Next Page
Loading...
