WEISS TS 003 E - Installation Instructions; Card Holder; Terminal PCB; Built-In Housing

130
145
197
136
68
252,5
15
6. Installation instructions
6.1 Card holder
The card holder is designed for installation fixing to din rails in rear of electrical panel. It has screw wiring terminals on the
left and right hand sides for the connection of the 24V and the control wires.
6.2 Terminal PCB
single terminal PCB (screw xing)
The PCB terminal is designed for installation screw xing.
6.3 Built-in housing
The terminal block is built into the
rear of housing.
This is our recommended
standard version
(din rail mounting)
Partial front plate
Basis
Rear
Card guide