Welbilt MERRYCHEF eikon e2s - Page 35

_______________________________________________________________________________________________________________________________
7 Preparing the appliance for use
Back to contents >
Merrychef eikon
®
e2s Installation and User Manual
35
_______________________________________________________________________________________________________________________________
Suitable cooking utensils
Check the manufacturer’s instructions and temperature rating to determine the suitability of individual containers or utensils
using each of the cooking functions. The following chart provides general guidelines:
Cooking utensils
Permitted
Notice
Heat resistant containers
Toughened glass
YES
Compatible vitreous ceramics
YES
Do not use items with metallic decoration.
Earthenware (porcelain, crockery, china, etc.)
YES
Metallic and foil trays
Any metal or foil containers
NO
Plastic containers
Dual-oven able plastic containers
YES
Use only plastic containers approved by the
manufacturer.
Disposables
Combustibles (paper, card, etc.)
YES
Use only combustibles approved by the
manufacturer.
Other utensils
Tie tags
NO
Cutlery
NO
No kitchen utensil should be left in a food product
while it is cooking in the cavity.
Temperature probes
NO
Start up
1.
Make all the relevant safety checks and ensure the appliance is clean
and empty.
Then switch the appliance ON.
2.
The easyTouch
®
screen illuminates with the display briefly showing
the serial number and appliance data and connectivity (KCCM) if
fitted.
If required, to keep the data on the screen, lightly tap the screen in
the centre once, to freeze the display. Tap again to continue.
If only one preheat temperature has been pre-set, the oven will then
automatically start heating up to temperature.
3.
When the appliance is set up with two or more preheating
temperatures a choice is displayed.
A scroll arrows at the bottom of the screen indicate that there are
more temperature choices not shown on the screen.
If necessary, use the scroll arrow in the bottom right of the screen to
view the other temperature options, or to return to the previous
selection. Then select the temperature required to start preheating
the cavity.