i16 Manual Page 13 - Revision: 2-09-2023
SERVICE REQUIREMENTS
WARNING! Read and understand the contents of this manual before attempting to
service the I16 Water Treatment System. Failure to follow the instructions in this
manual could result in death, serious personal injury, or severe property damage.
Only trained and qualified technicians should attempt to install, maintain, or service
Wellsys Equipment.
1. Visually inspect all electrical and water connections for signs of wear or damage.
DANGER! HIGH VOLTAGE ELECTRICAL HAZARD. Unplug before inspection and service.
WARNING! ULTRAVIOLET RADIATION. Protect your skin and eyes against ultraviolet
rays. Never look directly at an operating UV light. Disconnect before removing UV Lamp.
CAUTION! UV LIGHTS ARE HAZARDOUS. Lamps are considered Hazardous Waste and
must be disposed of accordingly. Refer to Product MSDS sheet for details.
2. Ensure there is adequate (minimum of 2”) clearance around the I16 Water Treatment
System and clean the condenser grill and compressor fan to provide efficient cooling system
operation.
3. Sanitize the unit per instructions in the sanitization procedures.
WARNING! SANITIZER MAY CONTAIN HAZARDOUS CHEMICALS. Use of proper personal
protective equipment such as rubber gloves and eye protection are required.
4. Clean and sanitize external surfaces of the I16 Water Treatment System. Use soap and
water or chemicals that are compatible with ABS plastic and will not damage or degrade the
product surfaces.
5. Remove and clean the Faucet. Replace as needed.
6. Descale Hot Tank Annually, or as needed.
To Next Page
Loading...