i16 Manual Page 26 - Revision: 2-09-2023
NOTES ON INSTALLATION
1. Do not install the product at the following locations:
- Near Fires
- Near Flammables
- In Humid Places
- In front of air conditioners
- Where exposure to rain or
snow is possible
- Outdoors or in direct sunlight
- Near chemicals (volatile
materials, organic solvents,
etc.)
- Near toilets
- Anywhere the temperature
may fall below 50°F.
2. Use source water within following quality range:
- Water pressure: 1-7kgf/cm² (98-686 kPa)(14-99.6psi)
- Water temperature: 39-100°F (4-38°C)
- Turbidity: 0.5 NTU or less
- pH: 5.8-8.5
- Hardness: 300ppm or less
- Water Quality: Water quality meeting the Drinking Water Quality standard
*Please consult your distributor if source water quality is out of the specified range.
*The warranty will be void if the product is connected to source water that is out of the
specified range.
*This product is not equipped with internal filtration. It is intended to be connected only
to a potable water source.
3. When transporting the product, do not tilt it more than 45° from vertical.
*Severe tilting can cause a performance degradation.
4. Install the product on a flat surface and adjust the level of the unit using a level gauge.
*If the product is tilted more than 3°, overflow may occur.
5. Source water should not be above 100°F (38°C)
*Hot water may cause performance degradation or system failure.
6. Keep the sides and rear of the unit at least 5 inches (127mm) away from walls or other
objects for ventilation.
7. Do not bend the source water hose or place heavy objects on it.
*If it is blocked, the water will not flow smoothly to the unit, and may cause
performance degradation.
8. Do not place any heating system near the rear of the unit.
9. The power supply and source water must be directly connected to the unit.
To Next Page
Loading...