ATA-171/172/171P/171M (ATA-S1/S2/P/M)
User’s Guide
34
3.11.9 Other Settings: you can setup the Hold by RFC, Voice/SIP QoS and SIP expire time in this
page. To change these settings please following your ISP information. When you finished the
setting, please click the Submit button. The QoS setting is to set the voice packets’ priority. If
you set the value higher than 0, then the voice packets will get the higher priority to the
Internet. But the QoS function still need to cooperate with the others Internet devices. When
you finished the setting, please click the Submit button. If there is nothing need to change,
please click the Save Change Item in the left side, then click the Save button. The change
you made will save into the system and the system will Reboot automatically.
Figure 24. Other Setting
3.12 NAT Trans.
3.12.1 In NAT Trans. you can setup STUN function. These functions can help your ATA working
properly behind NAT.
3.12.2 STUN Setting: you can setup the STUN Enable/Disable and STUN Server IP address in this
page. This function can help your TA working properly behind NAT. To change these settings
please following your ISP information. When you finished the setting, please click the Submit
button. If there is nothing need to change, please click the Save Change Item in the left side,
then click the Save button. The change you made will save into the system and the system
will Reboot automatically.
To Next Page
Loading...