WELLTECH ATA-171 - V2.0 - SIP Settings; Service Domain

ATA-171/172/171P/171M (ATA-S1/S2/P/M)
User’s Guide
29
3.11 SIP Settings
3.11.1 In SIP Settings you can setup the Service Domain, Port Settngs, Codec Settings, RTP
Setting, RPort Setting and Other Settings. If the VoIP service is provided by ISP, you need to
setup the related informations correctly then you can register to the SIP Proxy Server
correctly.
3.11.2 Subscribe for MWI : this function is offer voice mail notify.
3.11.3 I In Service Domain Function you need to input the account and the related informations in
this page, please refer to your ISP provider. You can register three SIP account in the TA. You
can dial the VoIP phone to your friends via first enable SIP account and receive the phone
from these three SIP accounts. For the second phone you can use the same way to register.
-1- First you need click Active to enable the Service Domain, then you can input the following
items:
(1-1) Display Name: you can input the name you want to display.
(1-2) User Name: you need to input the User Name get from your ISP.
(1-3) Register Name: you need to input the Register Name get from your ISP.
(1-4) Register Password: you need to input the Register Password get from your ISP.
(1-5) Domain Server: you need to input the Domain Server get from your ISP.
(1-6) Proxy Server: you need to input the Proxy Server get from your ISP.
(1-7) Outbound Proxy: you need to input the Outbound Proxy get from your ISP. If your
ISP does not provide the information, then you can skip this item.
(1-8) Register Period: you need to input the Register Period get from your ISP. This is
count in minute.
(1-9) You can see the Register Status in the Status item. If the item shows “Registered”,
then your TA is registered to the ISP, you can make a phone call direcly.
(1-10) If you have more than one SIP account, you can following the steps to register to the
other ISP.
(1-11) When you finished the setting, please click the Submit button.
(1-12) If there is nothing need to change, please click the Save Change Item in the left
side, then click the Save button. The change you made will save into the system and the
system will Reboot automatically.