UNPACKING
With the help of a friend or trustworthy foe, carefully remove the Metal Bandsaw from the packaging. Make sure to
take out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing
list below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact
our customer service at 1-800-232-1195 (M-F 8-5 CST), or email techsupport@wenproducts.com.
PACKING LIST (NOTE: The key is tied to the motor shaft. Hardware bag included but not shown below.)
ASSEMBLY/ADJUSTMENT TOOLS
The tools listed below are not included but are required for either assembly or adjustment:
• 14mm open end wrench (2)
• 10mm open end wrench (2)
TRANSPORTING
When transporting the Metal Bandsaw, use the transportation handle and roll the assembled saw with the
wheels. Never carry the saw by its guards or its accessories.
UNPACKING & TRANSPORTATION
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
9
Band Saw (1)
Stand
Leg A
(2)
Stand
Leg B
(2)
Long Brace
(2)
Short
Brace (2)
Table (1)
Work Stop
Rod (1)
Work Stop
(1)
Belt
Housing (1)
V-Belt (1) Motor
Pulley (1)
Work Gear
Pulley (1)
Wheel (2)
Shaft (1)
Whell Mounting
Bracket (1)
Table
Support (1)
Transportation
Handle (1)
To Next Page
Loading...
Need help?
General
