14
MAINTENANCE
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of the following conditions exist, do
not use until parts are replaced or the screwdriver is properly repaired.
Check for:
• Loose hardware or improper mounting,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CLEANING & STORAGE
1. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get into the tool.
2. This tool is permanently lubricated at the factory and requires no additional lubrication. There are
no user serviceable parts in your power tool. Do not try to open or disassemble your screwdriver or
replace the battery cell.
3. Keep ventilation slots of the screwdriver clean at all times. Prevent any debris from entering the
ventilation slots.
WARNING: To avoid accidents, turn OFF and unplug the tool from the charger before clean-
ing, adjusting, or performing any maintenance or lubrication work.
WARNING: Any attempt to repair or replace electrical parts on this tool may be hazardous.
Servicing of the tool must be performed by a qualified technician. When servicing, use only iden-
tical WEN replacement parts. Use of other parts may be hazardous or induce product failure.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, pene-
trating oils, etc. come in contact with the plastic parts. Chemicals can damage, weaken or destroy
plastic which may result in serious personal injury.
STORING THE TOOL
Always store your power tool in a dry place, frost-free location. To protect the battery from damage,
do not expose the tool to temperatures above 104°F (40°C).
DISPOSAL
When the product reaches the end of its lifetime, please do not dispose of it with household waste.
Electrical and electronic products are hazardous to the environment and human health due to the
presence of hazardous substances. Take the product to your local recycling facility for it to be re-
sponsibly recycled to minimize impacts on the environment.
Please recycle the packaging where facilities exist.
To Next Page
Loading...
Need help?
General
