SAFETY RULES FOR BATTERIES AND CHARGERS
8
CHARGING THE BATTERY
1. Before charging and using the battery, read all cautionary markings on the battery charger, battery
cable, and the product using the battery.
2. Only recharge the battery with the charger specified by the manufacturer. Do not use the supplied
battery charger to charge other cordless tools as undesirable risks such as fire or death may occur
when used with another battery.
3. Inspect the power tool and charger before charging. Do not operate the charger with a damaged cord
or plug.
4. Electrical plugs must match the outlet. Never modify the plug in any way. Do not use any adapter
plugs with grounded appliances. Do not attempt to use a step-up transformer, an engine generator or
a DC power receptacle.
5. This charger is for indoor use only. Do not expose to rain or use in damp locations.
6. Do not place the tool or the charger near fire or heat. Place the charger on a flat non-flammable
surface and away from open flame and flammable materials before charging.
7. Do not charge the tool inside a box or container of any kind. The tool must be placed in a well-
ventilated area during charging. Do not allow anything to cover or clog the charging vents.
8. Do not operate the charger or the tool if it has received a sharp blow, either from being dropped or
damaged. Take it to a qualified service technician before attempting to use.
9. Never use or charge a battery if you suspect that it has been more than 12 months since the last
time it was charged. There is a high probability that the battery has already suffered dangerous dam-
age (exhaustive discharge).
10. The battery will become warm during extended periods of use. Allow the battery pack to cool to
room temperature before charging it again. This will protect the life of your battery.
11. Always charge the battery pack between temperatures 32 to 86 °F (0 to 30 °C). Ideal charging tem-
perature is 64 to 75 °F (18 to 24 °C).
12. Disconnect the charger from the power source and the tool when not in use. This will reduce the
risk of damage to the charger during a power surge or if metal pieces should fall into the opening.
To Next Page
Loading...