STARTING THE GENERATOR
STANDBY MODE
Once the generator is shut down, the generator’s remote control function will stay in standby mode while the battery
switch is ON. In standby mode, the generator can be started using the remote. The engine start/stop button will blink
green once every 2 seconds to remind you that the generator is in standby mode.
NOTE: There is no limit to how long the generator will stay in standby mode, so if you forget to turn off the battery
switch, it is possible that the battery will be drained the next time you try to use the generator. If you see the engine
start/stop switch flashing green, always make sure the battery switch is turned OFF.
PAIRING MULTIPLE REMOTES
You can pair up to 15 remotes at a time with your generator. Remotes (part no. DF875iX-1432) can be purchased
from wenproducts.com. To pair a new remote with your generator, follow instructions above in “Pairing the Remote
and the Generator”. You can also pair one remote with as many generators as you like.
NOTE: If you have multiple remotes paired with your generator and you unpair one remote, you will also unpair
the other remotes simultaneously. You will need to pair the other remotes with the generator again before they can
be used. If at any point you have questions, problems, or concerns about the remote start function, consult the
Troubleshooting guide or contact customer service at 1-800-232-1195.
25
To Next Page
Loading...
Need help?
General
