WerkMaster TITAN XT - Monthly Maintenance Procedures; Troubleshooting; Troubleshooting Power and Startup Issues; Troubleshooting Operational Issues

OPERATOR’S!MANUAL!!
+,-.!/P!!
ISSUE
TEST
SOLUTIONS
Excessive noise or vibration
is felt or heard while running
the machine.
Disconnect the power and tilt the
machine back. Spin one pad by hand.
Listen for a clicking sound or grit-like
feeling.
• Check that all tooling is in the correct pin holes on the pad drivers.
• Replace the bearings. Contact technical support: 866.373.9375 for
instructions.
Tooling becomes dislodged
from the machine while
operating.
Disconnect the power and tilt the
machine back. Remove and inspect all
tooling. This includes the pins, tooling
plates, and pad drivers.
• If the pin holes are excessively damaged, replace the pad drivers.
• If the grommets/bumpers on the pad drivers are damaged, replace
the damaged parts.
• If the pins on the diamonds or tooling plates are damaged or
missing, replace the pins.
The machine handle
malfunctions.
Check the handle plug to see if it has
come loose.
• Secure the handle plug. If the handle controls are still
malfunctioning, contact customer service for instructions.
VFD makes popping noise
and starts to smoke.
***Disconnect power
immediately!***
Wait for 1–2 hours, then remove the
VFD cover and check electronic
components for discoloration, scorching,
or swelling.
• Contact a dealer or technical support: 866.373.9375.
VFD screen displays error
message or unusual screen
display.
Look up the message in the Appendix.
• Contact technical support: 866.373.9375.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!