OPERATOR’S!MANUAL!!
+,-.!K!!
WerkMaster machines come in a variety of voltage and phase configurations.
The TITAN XT is typically configured to operate on 208–230V three-phase
power. The TITAN XT is capable of operating on single-phase 208–230V power
with the use of the included adapter cord.
COLOSSOS XT is capable of operating with 230V three-phase to 460V three-
phase power with the use of the adapter cord. Runs on 230V or 460V auto
synching.
!
!
Pigtails are plug ends with unfinished bare wire on one end for hooking up to
panels. Pigtails are used when connectivity is unknown, when connecting to the
power grid of an unfinished building that has no power receptacles, or when
operating certain generators. Many pigtails are available or can be made up by
an electrician.
!
When using the TITAN XT in a residential environment, source power may be
hard to find. The use of stove and dryer adapter cords make it easier to connect
to single-phase source power. The adapter cords are outfitted with a 30 A 250 V
single-phase twist-lock cord end for dryers and 40A 250V single-phase twist-lock
cord end for stoves. The single-phase to three-phase adapter is used to connect
the stove or dryer adapter cord to the TITAN XT only.
!
The following table lists the minimum requirements for power cords.
!
!
Single-phase minimum gauge of 10/3
Three-phase minimum gauge of 10/4
Single-phase minimum gauge of 8/3
Three-phase minimum gauge of 8/4
!
!
!
!
!
Exercise extreme caution at all times when working with electrical power.
WerkMaster strongly recommends that only certified electricians be permitted to
work with electrical power sources within customers’ facility or on their job site.
!
!
!
!
!
To Next Page
Loading...