WerkMaster TITAN XT - Introduction to the Controls; Machine Handle Controls; Variable Frequency Drive (VFD) Controls

OPERATOR’S!MANUAL!!
+,-.!M!!
INTRODUCT IO N !TO!THE!CONTROLS!!
Starting the machine and changing the speed can only be done with the controls
on the handle.
USE THIS...
TO DO THIS...
Green Start
button
Start the machine.
Red Stop button
Stop the machine.
Speed control
knob
Control the speed of the pad drivers. You can set the speed
before the machine is turned on or adjust it while the machine is
running or unplugged. The speed control knob is analog and has
end points.
!
!
The TITAN XT and the COLOSSOS XT use a Vacon X4 Variable Frequency
Drive. The TITAN XT VFD allows the TITAN XT to be operated on either single-
phase or three-phase power. To operate on single-phase power, a single-phase
to three-phase adapter is required. The machine can operate on either 50 Hz or
60 Hz frequencies. The VFD will automatically adjust for phase or frequency
input.
The COLOSSOS XT 230/460 Dual Volt VFD allows the COLOSSOS to run on
either 230V or 460V auto-sensing between 230 and 460V. The machine to be
operated on 230V, 380V or 460V except on 230V only or 460V only models.
An adapter (not included) is required to convert to 460V. The machine can
operate in 50 Hz or 60 Hz frequencies. The VFD will automatically adjust for
phase or frequency input.
!
!
!
!
NEVER!open!the!VFD!panel!while!plugged!in!or!immediately!after!unplugging!the!
power!cord.!Severe!injury!or!death!may!occur.!
!
!
"@.!"#"$%!&"!,3 B !5 @ . !' ()(** (*!&"!=2B.41!7364;B.!NDF!62350241!4715.B!_.42G>!"@.!
E2442G73-!_;55231!,0.!426S.B!2;5!,1!5@.A!,0.!325!0.:;70.B!52!;1.!5@.1.!=,6@73.1b!
• D20G,0B!_;5523!\D^F]!
• L.8.01.!_;5523!\L9N]!
• c2-!_;5523!\c(I]!
• )26,4!`!0.=25.!_;5523!\)('`L9C]!
!
Machine Controls
VFD Controls
! ! ! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !DANGER!