EasyManua.ls Logo

Whirlpool 4322452 - Testing an Oven Glo-Bar Ignitor

Whirlpool 4322452
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 6-3
Steady State Current = 3.0 Amps @ 115 ±1 VAC @ 75˚F ±10˚
Ambient.
Cold Resistance = 500 TO 1100 @ 75˚F ±10˚ Ambient.
Maximum Operating Temperature Not To Exceed 2650˚F @
115 ±1 VAC @ 75˚F ±10˚ Ambient.
TESTING AN OVEN GLO-BAR IGNITER
If the glo-bar ignitor (see Figure 6-2) does not glow, perform the following steps to test it:
1. Turn off the gas and electrical power to the range.
2. Disconnect the oven igniter quick-disconnect plug from the main harness connector.
3. Connect an ohmmeter across the wire ends or terminals of the glo-bar. If the meter reads over
1100 , replace the igniter.
Carborundum Ignitor
Figure 6-2

Table of Contents

Related product manuals