Whirlpool AWD60A - Drying Methods; Turning on Power and Loading Laundry; Setting Drying Time and Delay; Program Operation and Completion

&OREVERYDAYEASEOFUSEWEHAVEPLACEDTHEDRYERS0ROGRAM$ESCRIPTIONSONTHEBACK
COVEROFTHEMANUAL,ISTEDBELOWAREMOREDETAILEDEXPLANATIONS
4URNINGONPOWER
Insert the power plug into an appropriate socket to turn on the power. Operating power supply:
(220-240)V/50Hz.
,AUNDRYLOADING
Open the door and place the treated laundry into the drum of the dryer. To save energy and
achieve a better drying result, please spin the laundry as dry as possible. Place the laundry evenly
into the drum after shaking them loose.
NOTE: Before the laundry is dried, check the labels on the fabrics carefully. Do not put laundry
that cannot be dried by a dryer into the dryer, particularly delicate fabrics, as high temperatures
may cause damage.
3ETTINGDRYINGTIME
Turn the program knob to set an optimal drying time according to the laundry.
$ELAYSETTING
You may choose to start the dryer after a preset time.
The delay range is between 1 and 12 hours.
0ROGRAMOPERATION
After a program is set, gently touch the Start/Pause button to start the program.
0ROGRAMCOMPLETION
Before the drying program comes to end, the dryer will enter in the cold air cycle where the
heating will stop.
After the program is complete, the display screen will display “End”. Open the door to remove
the laundry.
If the laundry is not removed after the drying program is complete, the dryer will start in the
anti-crease protection cycle automatically. In the anti-crease protection cycle, the dryer’s drum
will run in a set interval to keep your laundry loose for 60 minutes .
NOTE: Clothes should go through a cooling down/airing phase of the cycle. If for any reason the
dryer is stopped before the cycle has finished, dry clothes should be removed immediately and
not left in the dryer. Clothes should be spread out to cool and not left bunched eg. in a clothes
basket.
4URNINGOFFTHEDRYER
Turn the program knob to the “OFF” position and turn off the dryer.
NOTE: Clean the filter after dryer is unloaded.
DRYING METHODS
13
TumbleDryer_AWD60A-4.indd 13 5/8/08 4:26:02 PM