Whirlpool AWD60A - Cleaning and Maintenance; Cleaning the Surface; Cleaning the Filter Screen

5NPLUGTHEPOWERCORDPRIORTOANYCLEANING
#LEANINGTHESURFACE
Wipe off dust and dirt on the body of the dryer and the surface of the main control panel .
NOTE: Do not use excessive water, just a damp cloth.
Do not use solvents.
Do not use spray cleaners when cleaning the interior.
Do not use harsh or abrasive cleaners.
#LEANINGTHElLTERSCREEN
To ensure a good ventilation effect during drying, the filter
screen must be cleaned before or after each use.
s2EMOVINGTHElLTERS
Pick out the clip gently from the wind bar with your hand and
take down the lint filter.
s#LEANINGTHElLTER
Remove the lint with a soft brush or vacuum cleaner.
Pay attention not to damage the filters.
In addition, remove any remaining lint from the
perforated metal lint screen on the door.
s2EINSTALLINGTHElLTER
After cleaning, put the screen back in place.
NOTE: Never operate your dryer without the lint filter.
CLEANING AND MAINTENANCE
Warning
14
Metal lint screen
TumbleDryer_AWD60A-4.indd 14 5/8/08 4:26:05 PM